23
Troubleshooting Guide
If the unit does not operate normally when you follow the instructions indicated in the manual, please refer to
the table below.
SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
No power.
The power cord is not correctly
connected to the wall outlet.
The unit is in timer recording
standby mode.
- Connect the power cord firmly
into the wall outlet.
- This is normal, not a
malfunction.
No image displayed on the
monitor TV.
The connections are not correct.
The power to the camera and/or
monitor TV is not turned on.
- Check that all connections are
correct.
- Turn all connected devices
power on.
The buttons do not respond.
The unit is in timer recording
standby mode.
Alarm recording.
One-shot recording.
The security lock (SET LOCK) is
engaged.
- Press the Power/Timer button.
- Wait for the alarm recording to
end.
- Press the STOP button for 3
seconds to stop.
- Wait for the one-shot recording
to end.
- Press the STOP button.
- Cancel the security lock.
Unit will not go into record mode.
The loaded cassette has no
erasure prevention tab.
- Load a cassette tape with
erasure prevention tab or cover
the tab hole with adhesive tape.
Autorepeat
“NO” is selected for autorepeat
recording in the REC MODE
SETUP menu.
During autorepeat recording when
there is an alarm input, autorepeat
recording is canceled.
- Be sure to select “YES” for
autorepeat recording.
- Set “YES” again for autorepeat
recording.
