UFR1002IP
12690-0701-00
Seite
9 / 50
www.ziehl.de
7
Installation
•
mount on 35 mm mounting rail according to EN 60715
•
wall-mount with 3 x screws M4
•
connecting wires refer to the connection plan to prevent miss-operation and malfunction
8
Commissioning
8.1 Switch on the device
Switch on the supply voltage,
➢
The display turns on, after about 1s the device is ready for use
➢
The device language must be specified during initial startup. Use the joystick button to navigate to the
language you want (German/English) and select.
8.2 Set date / time
We recommend setting the date and time.
Functions such as the alarm counter and standby statistics require a correct date/time.
If a valid date/time is not yet stored in the device, you will be asked to enter the date/time.
Use the joystick button to make the appropriate settings and confirm these using the green tick.
After 2 minutes without input, the query is terminated.
The settings can also be changed at any time via the "Settings" -> "Date" or "Time" menu.
If the device (with connected Ethernet cable) receives valid network data via DHCP, it automatically tries to
contact a time server to get the current date/time from there.
8.3 Device on the network
If the UFR1002IP is connected to a network via an Ethernet, the measured value display and programming
can be performed via a web browser on the computer.
Basic knowledge of network engineering is required for configuration.
8.3.1 Find devices on the network
Network with DHCP server:
After connecting to the network, the device will automatically receive an IP address.
Retrieve IP address on the device:
•
Use the joystick (←/→) on the device to switch to the info display page
o
IP address is displayed
•
In menu mode (press and hold the joystick for
↓
2 s), call up the menu item "Network"
o
Settings for the network parameters DHCP, IP address and subnet mask can be viewed and
changed
Set network without DHCP server / manual IP address:
The relevant network parameters can be set and changed directly on the device:
•
In menu mode, call up the menu item "Network"
•
Configure the network parameters DHCP, IP address and subnet mask
Connection:
Open the web browser on the computer and enter the IP address in the address bar.
8.3.2 Access via web browser
After the IP address is accessed, the device logs on to the web browser.
Internet access should be secured using a VPN connection.
