12
Protocol
12.1
Display and query of events and malfunctions
Main menu
Events during operation can lead to a malfunctioning of the device.
The last 100 events are saved in the
“
Protocol
”
menu group.
Position 1 = latest event, display: Protocol 1/100
Position 100 = last saved event, display: Protocol 100/100
The saved events are retained even after resetting to factory setting (
menu
group Start / PIN input)!
Start
Setting
Protocol
Base setup
Controller Setup
Event types
The device distinguishes between several event types which are identi
fi
ed by different symbols.
Message by alarm relay depending on the type of failure and programming.
Example:
Protocol
1/10
Attention symbol = message
Sensor 1
The message is only listed in the protocol. There is no message alternately with
the actual value display and no message via alarm relay.
Exception
In case of sensor failure there is always a message in the display (
Controller
Setup / Alarm Sensors) .
Detail
Protocol
2/10
Bell symbol = error with alarm message
Communication
Errors at which the device automatically goes into operation (e.g. overload) or
stays in operation (e.g. communication errro) after clearing the fault.
The fault message is listed in the protocol and appears alternately with the actual
value display.
Detail
Protocol
3/10
Cross in circle symbol = switch-off error
Motor fault
Errors which lead to switching off the controller output (e.g. motor overtemper-
ature). Restarting is only possible after a reset (interlock)
The fault message is listed in the protocol and appears alternately with the actual
value display.
Detail
Protocol
4/10
Cross symbol = previous messages
IGBT Temp.
Cause of the message no longer exists.
Detail
Details of events
Example: Motor fault
Protocol
5/10
Motor fault
Detail
Press the key to show further details.
Operating Instructions
Fcontrol
–
model series FXDM25/32AM
Protocol
L-BAL-E212-GB 1451 Index 003
Part.-No.
114/123
