ZIEHL-ABEGG FXD32AM, Operating Instructions Manual

Page: 50 / 123

Setting Manual mode
“
OFF
”
= automatic control as function of the set parameters (Factory setting)
“
ON
”
= automatic control without function, speed setting in menu
“
Speed manual
”
OFF
Manual mode
Setting Speed Manual mode
Manual speed setting without in
fl
uence by the external signal.
Activation by menu
“
Manual mode
”
or external contact at digital input ( IO Setup).
Setting range: 0...
“
Max. Frequency
”
( Motor Setup)
Factory setting: 50.0 Hz
For information about deactivated regulation the adjusted value for manual speed is
indicated alternating with the actual value.
50.0 Hz
Speed man.
Additional menu item for mode 5.02 with outside-temperature dependent target-setpoint
Outside-temperature dependent target-setpoint
Außentemperatur
P-min SA
[m
3
/h]
-15 °C
min. Temperatur
30 °C
T-Start
Sollwert 1
[m
3
/h]
Sollwert 2
[m
3
/h]
07.02.2007
v_sollwert_aussentemp_abhaengig_m3h.vsd
S1 Setpoint1
S2 Setpoint2
P-Min SA Minimum air volume
T-min Minimum temperature
T-Start Setpoint reducing will start below this outside temperature
AT Outdoor temperature
An outside temperature compensation can be
activated (sensor connection
“
E2
”
to
“
Analog In
2
”
) when being operated as a air volume regu-
lation device.
An optimal building climate, e.g., can be
achieved through this. Through this function,
the set and active Setpoint 1/2 is automatically
changed proportional to the measured outside
temperature (
Info:
“
Setpoint control
”
).
Setting T-Band SA
Temperature range in which the setpoint change continiously with outside temperature
Setting range: 0.0..100.0 K
Factory setting: 30.0 K
30.0 K
T-Band SA
Setting T-Start SA
Setpoint reducing will start below this outside temperature
Setting range: -10.0...40.0
°
C
Factory setting: 15.0
°
C
15.0 ° C
T-Start SA
Setting Min. Setpoint
Minimum pressure for very low outside temperature
Setting range: depending on measuring range of sensor and
“
K factor
”
Factory setting: 700 m
3
/h
700 m
3
h
Min. Setpoint
Operating Instructions Fcontrol
–
model series FXDM25/32AM Programming
L-BAL-E212-GB 1451 Index 003 Part.-No.
50/123