2. Getting Started
9
CPU Boards supporting the ZT 8954:
Note:
As CPU boards are designed, this list will change. Contact Ziatech for details on
boards not listed here.
•
ZT 8902 Revision A
•
ZT 8903
•
ZT 8904
•
ZT 8905
CPU Boards NOT supporting the ZT 8954:
Note:
As CPU boards are designed, this list will change. Contact Ziatech for details on
boards not listed here.
•
ZT 8801/88CT01
•
ZT 8802/88CT02
•
ZT 8808/8809/88CT09
•
ZT 8816/8817
•
ZT 8901/89CT01
•
ZT 8902 Revision 0.X
•
ZT 8910
•
ZT 8911 Revision 0.X (although slot-specific DMA can be used)
Physical Requirements
The ZT 8954-D1 and ZT 8954-D0 require just one STD 32 card cage slot. The
maximum board height, including the floppy disk drive, is 0.5". Note that boards placed
to the left of the ZT 8954 should be chosen with care so that they do not exceed the
maximum height limit. Should this happen, select another board to install next to the
ZT 8954. Note that the top of the floppy disk drive is shielded to protect against shorting
adjacent boards.
The ZT 8954-D3 requires three STD card slots. Refer to the "
Card Dimensions and
Weight
" section of Appendix B, "Specifications," for exact dimensions of the ZT 8954.
Power Requirements
Power required by the ZT 8954 depends upon the type of drive loaded on the controller.
Consult Appendix B, "
Specifications
," for details. In general, the ZT 8954 and drives
shipped with it do not r12 V. Only +5 V is required for the complete assembly.
Some older drives do use +12 V, and they can be powered through the ZT 8954 via the
J5 power connector
.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
