Zetor FORTERRA HSX 100 2014, Operator'S Manual, Page: 223 / 250

224
ADJUSTMENT
F_02_142 FH12N019
ADJUSTMENT OF THE LIFTING DRAW-BARS OF THE HITCH FOR A SINGLE-
AXLE SEMI-TRAILER

Raise the hydraulic arms to the upper - transport position with the position control
selected and the vibration compensator off.

Screw the nuts on the adjustable draw-bars towards the guiding pipe without any
play.

Tighten the nuts by another 3.5 turns.

Check whether it is possible to tilt off the supporting hooks freely.

By lowering and repeated lifting of the hydraulic arms to the transport position check
whether the engine does not tend to “stall" at the idle speed - the relief valve of the
hydraulic pump must not be in operation.

Then, lower the arms slightly.
ADJUSTING THE BOWDEN CABLE
It is performed if the carrier with the tow-
ing hook is in contact with the supporting
hooks. The Bowden cable must be ten-
sioned to avoid any play of the control
lever in the cab. Then, the cable is se-
cured against loosening with a nut.