Zetor Forterra CL 100, Operator'S Manual

Page: 171 / 198

Insertion piece replacement of the oil cleaner with delivery filter of the gearbox switchboard
Filling, controlling and draining hole of oil of front drive axle
Filling, controlling and draining hole of oil of front wheels reducers
Front PTO
Oil cleaner is placed on the left side of the gearbox. The
cleaner clogging is signalized by a control on dashboard
lighting up.
Before replacing the insertion of the oil cleaner,
place a suitable vessel under the tractor for catching
the dripping oil.
1. Unscrew the body of the cleaner (1)
2. Replace the insertion filter
3. Do the back assembly of the body of the cleaner
FH12N055
1 - lubricating nipple of the kingpin
2 - sliding bearings (2 pieces) of the front driving axle
3 - drain opening of the final drive hous-ing oil
4 - filling and inspection opening of final drive housing oil
(after removing of the inspection screw the oil level must
reach the bottom edge of the inspection opening)
E733
Inspection, filling and draining oil is done by a one hole
after turning reducer according to figure.
1. amount of oil inspection - hole in the horizontal axis of
a reducer (after unscrewing control screw the level of oil
must reach the brim of checking hole)
2. filling oil - hole at the top
3. draining hole - hole at the bottom
C731
The inspection and filling plug of oil (1) is situated on the
front side of the front PTO case.
Note:
The front PTO with the standard turning direction is
equipped with a hollow bolt of the oil cooler hose instead
of the inspection and filling plug. Perform the check after
removing the hollow bolt.
After unscrewing of the inspection plug the oil
level must reach the bottom edge of the inspection
opening. During the oil replacement the oil cleaning
strainer (2) must be cleaned. The cleaning strainer is
accessible after the disassembly of the locking ring
and removal of the cap.
F206
MAINTENANCE INSTRUCTIONS
170