72
7. After the lugs have adequately cooled, carefully squeeze the crimp rings back down onto the
wire.
240
This should be snug enough to hold the wire in place, but not so tight that you damage
or cut through the insulation!
241
240
241
8. Carefully slide the plastic sleeve along the wire and over the contacts.
242
242
9. Slide the jack barrel along the wire and over the jack. Screw it on tight.
243
Take the jack out of
the clamp or vise and this baby is done.
243b
243
243b
10. Test the continuity of the cable with your multimeter. Set your meter to the continuity setting (or
Resistance setting).
a. Test for continuity from the jack tip (the positive point) to the end of the wire with writing. A
continuity tester will beep; a resistance meter should show very low resistance, like, less than
one ohm.
Summary of Contents for THE PERCOLATOR
Page 83: ...83 That s it The baffle board is done Set it aside until the cabinet is complete 284 285 286...
Page 89: ...89...
Page 90: ......
