59
37. Check the box for overall squareness: Set the cabinet on its back and drop the baffle board into
place. Does the opening seem reasonably square? If not, clamp the baffle board into the acute
corner as shown.
183
(We demonstrate this here on a 1x8 speaker cabinet shell.) This will pull the
whole box into perfect square. Now tighten all eight cabinet screws.
184
If necessary, use the
other clamp to hold the joints tight as you drive the screws home. Do not over-tighten! You will
only sink them too deep into the side, or spin them out, or worst, break off the head. Proceed
carefully with a screw driver, or a cordless screw gun with the clutch set low (1, 2 or 3).
183
184
38. Move the bar clamp to the lower Port and clamp it tightly to the Bottom.
185
Fit the upper Port in
place, flush with the tops of the rear cleats or a hair higher.
186
185
186
39. Drill six holes 5/64 x 1-1/8” deep through the ports where marked and into the cleats.
187
187
Summary of Contents for THE PERCOLATOR
Page 83: ...83 That s it The baffle board is done Set it aside until the cabinet is complete 284 285 286...
Page 89: ...89...
Page 90: ......
