28
5. Label (Part # PL11): Clean the front of the chassis with a clean rag moistened with isopropyl
alcohol, denatured alcohol, or rubbing alcohol.
68
Clean it thoroughly, and allow any liquid to
dry completely. Be careful NOT TO TOUCH the face AT ALL
after cleaning. The oil on your fingertips will leave prints
that will interfere with the bond of the label. Test fit the
label, then peel off the back and carefully set it in
place.
69
GET IT RIGHT THE FIRST TIME! YOU WILL
NOT BE ABLE TO RE-POSITION THIS LABEL! Line up
the bottom edge of the label with the bottom edge of
the chassis; then align some of the chassis holes, drop it
in place, and rub it down firmly over the entire surface.
68
69
6. LED bezel (Part # SK05): Install the plastic LED bezel into its hole on the front of the chassis
(through the label).
70
It goes in the hole to the right of the ZDL logo. It should easily snap into
place.
TIP:
If the label
is slightly misaligned over
one of the edges or holes use
a razor blade or xacto knife to
trim off the excess.
70
Summary of Contents for THE PERCOLATOR
Page 83: ...83 That s it The baffle board is done Set it aside until the cabinet is complete 284 285 286...
Page 89: ...89...
Page 90: ......
