30
d. Place the washer and nut back on the pot, and snug down with your pliers.
74
Place the plastic
nut back on the input jack,
75
and snug it down with your pliers. Do not over-tighten this nut or
the label could start warping.
e. Use your needle nose pliers to bend the LED over to fit inside of the LED bezel on the front of
the chassis.
76
Be sure not to twist the LED or the leads might touch and short out against each
other. Push the LED through the bezel until it snaps into place.
8. Knob (Part # KN05): Turn the pot all the way counter clockwise. Place the knob on the pot and
align the white line on the knob to the position where you want the volume to be off (usually
between 1:00 & 2:00, when the amp is upside down). Use a small flat screwdriver to tighten the
set screw until the knob is tight.
77
Now turn the knob all the way right and left through its travel.
The line should be between 10:00 & 11:00 at the maximum clockwise position. The goal in
setting the knob is to make the 6:00 position of the knob (when the amp is upside down) be the
half way point of the pot turn, in other words, the turning distance either side of middle should be
equal. If it’s not right, loosen the screw, adjust the knob, and re-tighten. It may take a few times of
re-adjustment to get the knob/pot position where you want it.
74
75
76
77
Summary of Contents for THE PERCOLATOR
Page 83: ...83 That s it The baffle board is done Set it aside until the cabinet is complete 284 285 286...
Page 89: ...89...
Page 90: ......
