23
MAN0585.P65
Issue 01 - 11/99
2987M5023
2. USING THE MINIGAS MK5
Note: If any of the steps described above fail to occur, check
for fault indications as described in Section 2.16.
2.4.2
Displaying the Instrument Serial Number
To display the instrument’s serial number, proceed as follows:
(1)
Switch off the Minigas Mk5 (see Section 2.5).
(2)
Press and hold the
O button on the right hand side of
the Minigas Mk5.
(3)
Press and release the I/O button on the left hand side.
(4)
The 8-digit serial number appears on the screen as two
digits in each of the four display banks and is read in the
conventional order:
upper left - upper right - lower left - lower right
The serial number is displayed for eight seconds or for
as long as the
O button is held depressed.
(5)
Release the
O button and the Minigas Mk5 proceeds
with the start-up and self-test sequence.
2.4.3
Datalogging Warnings
One of the requirements of the datalogging facility is that it
should be transparent to the user. That is, the process of logging
the measurement data and alarms should not interfere in any
way with the conventional use of the Minigas Mk5 as a personal
gas monitor. Consequently, any warnings associated with this
facility appear only during the start-up sequence; no indication
is given if any of these conditions occur during use.
