Zeiss S8, Instructions For Use Manual

Page: 74 / 148

74
Operation
G-30-1346-en S8 Floor Stand Issue 4.0
Printed on 05. 06. 2001
Basic mode
The basic mode is always displayed in the normal operating status.
Depending on the surgical microscope installed, the following parameters
are displayed in the basic mode:
Setting the user ID (USER)
After you have switched on the instrument, the basic mode is automati-
cally displayed.
The bottom display in the basic mode always shows the current user ID,
i. e. the user ID selected the last time when the instrument was shut down.
When the instrument is switched on, all system parameters stored for this
user are loaded.
You can store a maximum of 9 different user records.
Use the "
∇
" and "
∆
" keys assigned to the bottom display to select a user
ID between 1 and 9.
Saving parameter settings
As soon as you have entered a parameter setting, it is saved under the
current user ID.
Note:
If possible, each user should be assigned his own user ID under which he
can enter and save his specific parameter settings. This permits each
user to call up his specific set of parameters via his user ID and to work
with these settings.
Caution:
Make sure never to change the settings of another user. It is therefore ad-
visable that you only use your own user ID for your work. Remember that
all settings made are stored under the user ID currently selected.
Top display the current brightness of lamp 1
Middle display with OPMI
®
VISU 200 or OPMI
®
PRO magis
on the ceiling mount (floor stand):
the current brightness of lamp 2
with OPMI
®
Vario on the ceiling mount(floor
stand): optionally the working distance or
the total magnification
Bottom display the user ID
MODE STORE MANUAL
USER
1
250 mm
1
5.0
Basic mode