Zeiss Primostar 3, Instruction Manual

Page: 46 / 112

4 Installation | 4.3 Installing Additional Components ZEISS
7. Plug the other side of the RJ12 cable into the
RJ12 female connector port of the reflected-
light fluorescence illuminator.
8. Hide the RJ12 cable at the rear side groove of the reflected-light fluorescence illuminator.
9. Place the tube onto the reflected-light fluores-
cence illuminator (see Installing or Changing
the Tube [
}
43] ) and tighten the clamping
screw of the reflected-light illuminator.
10. If required, place the yellow filter onto the luminous-field diaphragm, see Attaching or Re-
moving Yellow Filter or TL Cover Plate (Fixed Köhler Stand) [
}
47] .
Info
Special eyecups with light protection (see Changing the Eyecups [
}
57] ) are used for fluores-
cence applications if no darkroom is available. However, they cannot be folded over and are,
therefore, not suitable for spectacle wearers. For this reason, spectacle wearers should use the
standard eyecups.
Info
For mounting reflected-light fluorescence illuminator iLED on stands with small hand lift,
please contact an authorized ZEISS service representative.
46 Instruction Manual ZEISS Primostar 3 | en-US | Rev. 1 | 415501-7011-111_en