Zeiss CONTURA, Operating Instructions Manual

Page: 77 / 158

Preparations for start-up
61211-1310402 CONTURA
6-9
Attaching the holders to the profile rail
The version of the holder used depends on the probing system. Gener-
ally, fastening is the same for all versions. All holders are fastened to the
profile rail using Allen screws. For VAST holders two screws are required,
while other holders only require one.
The holders are generally preassembled. The procedure for moving, re-
moving or adding a holder is described in the following.
NOTE
With RDS probing systems, two washers are required to fasten the
holder to the profile rail.
The minimum distance between two holders must be 150 mm.
Example of how to mount a holder for the VAST adapter plates:
A Cap
B VAST holder; top view
C VAST holder; front view
1 Slot nut
2 Screw; M6 x16
3 Cover of a holder
4 Brush for cleaning the adapter plate
1 Remove the cap [A] .