Axioskop 2 FS
plus
START-UP
Axioskop 2 FS
MOT
Attachments and conversions
Carl Zeiss
B 40-076 e 02/01
2-27
2.2.7
Changing the HAL 100 halogen
lamp
•
Switch off the separate power unit of the
halogen lamp as described in section 2.1.12,
remove illuminator plug from the 12 V / 100 W
socket of the power unit and allow the unit to
cool down for approx. 15 minutes.
•
Loosen screw (2-36/
5
) until the lamp housing
can be removed in an upward direction.
•
Press both spring levers (2-36/
3
) downwards
and pull out the old halogen lamp (2-36/
2
) in
an upward direction.
•
Press both spring levers downwards, insert new
lamp, with protection cap (2-36/
1
) being
attached in lamp base (2-36/
4
), let go the
spring lever and pull the protection cap off.
•
Press spring lever briefly downwards again to
center the lamp.
•
Attach lamp housing again and tighten
clamping screw (2-36/
5
).
2.2.8
Changing the HBO 103 W/2 mercury pressure short-arc lamp
Before opening the lamp housing, make sure that no connection to the electrical line is
available.
The HBO 203 W/2 lamps may only be changed after they have cooled down. Allow the
HBO 103 microscope illuminator to cool down for approx. 15 mins to avoid the risk of burns.
The HBO 103 W/2 lamp may only be removed from the packaging and inserted in the
HBO 103 illuminator if a protective mask and safety gloves are worn.
All electrical clamping connections must be made carefully. Pronounced heat during operation
may result in loose contacts.
Fig. 2-36
Changing the halogen lamp
Summary of Contents for Axioskop 2 FS mot
Page 1: ...Operating Manual Axioskop 2 FS plus FS MOT Research Microscope...
Page 14: ...INTRODUCTION Axioskop 2 FS plus Carl Zeiss Axioskop 2 FS MOT 0 14 B 40 076 e 02 01...
Page 110: ...OPERATION Axioskop 2 FS plus Carl Zeiss Axioskop 2 FS MOT 3 40 B 40 076 e 02 01...
Page 122: ...ANNEX Axioskop 2 FS plus Carl Zeiss Axioskop 2 FS MOT A 2 B 40 076 e 02 01...
