17
and one
mode.
Test again with known-good barcodes. If results are good, you are done setting
up. Otherwise, r
Figure 15: Programming Procedure
6.3 Set
Up
1. When the scanner is powered on (blue LED lights), find the <Enter/Exit
Programming Mode> barcode in the Programming Guide and present this
barcode to the scanner. When the scanner gives two beeps (one low
high) and the LED turns red, it means the scanner is in programming
2. Decide which parameters are required and find their barcodes in the
Programming Guide.
3. Cover unwanted codes with your hand and present the desired codes one by
one to the scanner; the scanner beeps once as it accepts each code.
4. When done, again present the <Enter/Exit Programming Mode> barcode.
5. The scanner beeps twice of the same tone, and the LED returns to blue. It
means the scanner has been programmed.
6.
eturn to step 1 and try again.
Read
Enter/Exit Programming Mode
barcode to start configuration
Change scanner setting by scanning the
barcodes of the desired function
Read
Enter/Exit Programming Mode
barco
de to save and exit
Summary of Contents for Z-6182
Page 1: ......
Page 8: ...3 Finding Your Way Around 3 1 Outline Figure 1 Outline 3...
Page 33: ...12 Dimension Unit mm inch 28...
Page 34: ...13 Decode Zone 29...
