Zebex Z-6182, User Manual

Page: 12 / 36

4.3 Connecting Auxiliary Scanner
To connect an auxiliary scanner to the AUX port:
1. Connect the auxiliary interface cable to the auxiliary port of the scanner.
2. Connect the other end of the cable to the auxiliary scanner.
3. Connect the power supply if necessary.
4. Use the programming barcodes to activate the auxiliary port of the vertical
scanner and set up its data transmission mode. (Refer to its separate
Programming Guide.)
4.4 Connecting EAS
The scanner’s integrated EAS deactivation antenna requires an EAS host cable.
1. Make sure that the power of the EAS system is off.
2. Plug the cable to the appropriate connectors on the scanner and the EAS
system as illustrated in Figure 4.
3. Turn on the EAS system.
4.5
Verifying Scanner Operation
Before mounting your scanner, please follow the procedure below to verify
scanning operation.
1. Take a stick to poke in the hole at the back of the scanner to remove the
mounting plate.
Figure 5: Mounting Plate Removal
2. Insert the 10-pin modular plug of the interface cable into the “Host” connector
7