Zebex Z-6182, User Manual

Page: 14 / 36

Figure 9: Put the mounting plate back
6. Plug the other end of the cable to the host.
7. Plug the power adapter into the jack on the interface cable.
8. Plug the AC end of the power adapter into an AC outlet. The scanner powers
up, the speaker sounds four beeps and the LED indicator glows blue.
9. Present a known-good test barcode to the scanner. The scanner should issue a
short beep and the LED should flash red momentarily.
If the scanner is connected to a keyboard wedge for this test, it should
read one barcode, beep, and the LED remain red. This is normal when
the keyboard wedge is not connected to a live host terminal.
The LED would flash red and read no barcode if the scanner is
programmed in USB interface but not connected to a host device.
If the scanner does not produce any beeps, or produces the wrong
beeps, or the LED is not lit up, remove the power connection and refer
to the section of Troubleshooting.
4.6 Interface Cable Replacement
The interface cable comes with different host-end connectors, and there are 5
standard types of interface connection that this device supports:
(a) Keyboard wedge
(b) RS-232 interface
(c) USB interface (supporting HID USB, virtual COM, OPOS USB)
The standard interface cable is attached to the scanner with a 10-pin modular
9