Zebex Z-6182, User Manual

Page: 21 / 36

16
. Site Preparation
t
an
ents using the programming barcodes in the separate
time,
mbologies, and more advanced settings like setting headers and
when
l parameters may be set at any time
ithout affecting the other parameters.
steps below to ensure that your scanner can work well with your host
ED lights) and the host system on, try to scan
n. If the scanner is reading okay, it is likely
S screen does not show the expected scans, go to the Set Up section
below.
6
6.1 Configuring the Scanner
In certain cases no setup is required. The scanner is either pre-programmed to sui
the situation, or it automatically detects and is ready to go. In other cases the
scanner must be informed about what kind of system it is connected to. This c
e done in a few mom b
Programming Guide.
The programming section may be used to set a number of parameters on the
scanner: communication interface type, sleep mode timing, same-code delay
arcode sy b
trailers.
The settings are to be stored in non-volatile memory and are preserved even
he scanner is powered down. Individua t
w
6.2 Scan
Test
llow the Fo
system.
. With the scanner running (blue L 1
several known-good barcodes.
. Check the results on the POS scree 2
that no further setup is necessary.
If the PO 3.