Advanced Setup
50
Configuring the Wireless Access Point
Table 5-14. Advanced Setup Menu
Item
Description
Device Time Setting
When Use Time Server is set to Yes, the device can be set to get
the time from the time server. In this section, you can also choose
the time zone of your country/region, adjust for daylight savings
time, and set the date and time yourself.
Flow Balance Mode
Disable or choose the flow balance mode to increase network sta-
bility. You can choose flow balance based on the number of
users, flow of data, or dynamic balancing.
Enable VoIP Control
Setting the maximum number of Voice Over Internet Protocol
(VoIP) sessions allowed based on IP addresses.
Enable Ping Test
If this item is enabled, you may set the destination IP address to
test. If you set Enable Reboot to Yes and ping times out within
about 6 minutes, the device will reboot; if you set it to No, the
device will set a ping packet every 1 minute.
Enable ART Test
Mode
Enable or disable the Atheros Radio Test (ART).
Enable DHCP
Snooping
If this item is enabled, multicast data will be sent to the VAP that
needs to be sent on to replace the original broadcasts.
Enable IGMP
Snooping
If this item is enabled, unicast data is sent to the suitable VAP that
needs this multicast data, and then replace the broadcast. This
function may be used only in AP mode.
Enable Spectrum
Navigation
Allows the STA preferential use of 5GHz to access the network,
thus improving the user experience.
Enable DHCP Relay
This function works in Router mode. When this item is enabled,
the wireless terminal client can obtain an IP address from a
DHCP server on the WAN side.
IGMP Proxy Mode
Disable or specify the upstream and downstream interfaces to
use the Internet Group Management Protocol (IGMP) Proxy
Mode. This function may only be used in Router mode.
Broadcast Storm
Control
Allow the port to filter broadcast storms on the network.Allow the
port to filter broadcast storms on the network.
Enable Refuse XDos
Enable this item to prevent XDox attacks.
VAP Isolation
If this item is enabled, the AP blocks communication between
wireless clients on the same virtual access point.
Auto Reboot Mode
If this item is enabled, the device can be set to automatically
restart on a periodic basis, depending on your selection of hours
or days.
