AF6ZP0AL - COMBIAC0 & ACE0 - User Manual
Page - 41/79
10.4.3 Main menu “PARAMETER CHANGE” functions list
To enter the MAIN MENU’ it is just necessary to push the ENTER button from the
home display in the hand set.
1) Opening Zapi Menu
CA0Z2A ZP1.00
24V 200A 00000
2) Press ENTER to go into the General Menu
' % '
' ' '
3) The Display will show: PARAMETER CHANGE
MAIN MENU
PARAMETER CHANGE
4) Press ENTER to go into the Parameter
Change menu
' % '
' ' '
5) The Display will show the first parameter
ACC DELAY
LEVEL = 5
6) Press either ROLL UP and ROLL DOWN to
display the next parameter
% ' '
% ' '
7) The names of the Parameters appear on the
Display
RELEASE BRAKING
LEVEL = 5
8) When the desired Parameter appears, it’s
possible to change the Level by pressing either
SET UP or SET DOWN buttons.
' ' %
' ' %
9) The Display will show the new level.
RELEASE BRAKING
LEVEL = 2
10) When you are satisfied with the result of the
changes you have made, press OUT.
' ' '
' % '
11) The Display asks: “ARE YOU SURE?”
ARE YOU SURE?
YES=ENTER
NO=OUT
12) Press ENTER to accept the changes, or press
OUT to discard them.
' ' '
' % '
13) The Display will show
MAIN MENU
PARAMETER CHANGE
1) ACCELER.
DELAY
Seconds. It determines the acceleration ramp. The parameter sets the time
needed to speed up the traction motor from 0Hz to 100Hz.
2) RELEASE
BRAKING
Seconds. It controls the deceleration ramp when the travel request is
released. The parameter sets the time needed to decelerate the traction
motor from 100Hz to 0Hz.
