Zap 8825-R4 Installation Instructions Manual Download Page 12

Page: 12 / 15

____________________

QUICK PROGRAMMING GUIDE

Radio programming using the LEARN button (see page 9)

Locate the small

LEARN

button on the top edge of the radio receiver module inside

the Control Box. Press the

LEARN

button:

program

a transmitter, release the learn button when the receiver light comes on:

Press and hold the required button on the

transmitter

until the receiver light starts to

flash.
To

erase

all stored transmitters, release the learn button when the receiver light

turns off again (after about 12 seconds).

Installer programming using the PROGRAM Button

Press and

HOLD

the

PROGRAM

button, there is one beep every 3 seconds:

Release the PROGRAM button after the

first

beep for the

calibration reset

–

see pages 9 & 10 for further details.
Release the PROGRAM button after the

second

beep to alter the

obstruction

tolerance

There are 15   beeps representing increasing tolerance to   obstructions – press and   release the ILLUMINATED
button   after the required   number of beeps.    The default setting is 6   and a calibration reset (pages 9 & 10)   is
required for   any new setting to take effect.
Release the PROGRAM button   after the

third

beep to alter the

open stopping mode

This alternates between programming the control head to open to a physical obstruction such as pusher

springs   or the cable drums   (2 beeps and 2 flashes)   or   open to the height   determined during the initial slow
calibration   runs   (1 long beep and 2 flashes).   The default setting is to open to a   physical obstruction.    A
calibration reset (pages 9   & 10) is required for a new setting to   take effect.
Release the PROGRAM button   after the

fourth

beep to program the

closing speed change point

14 beeps representing 2” height increases with 4” cable drums – press and release the ILLUMINATED button

after the   required number of beeps e.g. the default   of   6   beeps will cause the door to slow down when it is
12”   from the   ground.   A   calibration reset may be   required after altering   the   closing   speed change   height.
Release the PROGRAM button   after the

fifth

beep to alter the

soft start time

Press and release the ILLUMINATED button after the required closing soft start time (0.5 to 10 seconds,
default 4). The door will ramp up to full closing speed within the programmed time. The opening soft start

time is set to half the closing soft start time. A calibration reset may be needed after changing the soft start.

Service programming using the illuminated button

Unplug the power cable or switch off the power, press and

HOLD

the

ILLUMINATED

button and plug the power cable back in or switch on the power -‐

there is a beep every 4 seconds:
Release the ILLUMINATED button after the

first

beep to alter the

auto-‐close timer

Press and release   the   ILLUMINATED button to start   timing and press and release
the ILLUMINATED button   again after the   required time (5s to 96s,   default 15s).
The auto-‐close DIP switch on the control board must be switched ON for   the   auto-‐

close function to be active.   The beeper will sound and the operator light will flash
during the final 5 seconds prior to   the start of an   automatic close.
Release the ILLUMINATED button   after the

second

beep to store the

reversing decision height

LEARN

button