DOC-USR-0135-01
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
15
“225.1.2.3”. If you are on a shared network, check with your Network Administrator.)
(12)
Make note of the value of “Dest Port” (This will be “5004” by default).
(13)
The encoder may have already started (after 20 seconds, the encoder will automatically try to
start). If it has, click on “stop” near the bottom of the screen. The status will then change to
“STOPPED”. Then click on “start”. Once you do this, the status will change to “RUNNING.” If the
encoder hadn’t started already, simply click on “start” and observe the status change.
*Note
:
If you want to encode 1080p60, you must first change “Operating Mode” at the bottom
right from “Encode Interlaced/Progressive” to “Encoder Single Ch HD”. Note that, in “Encoder
Single Ch HD” mode, only CH1 can be used.
Figure 8 CH1 Tab Configuration – UDP
(2) Change
to UDP
(3) Change to IP
address of your
PC or multicast
address
(4) Note “Dest Port”
value
(1) Change to
“1920x1080” or
“Follow input”
(5) If necessary, click “stop”
(6) Click “start”
