Z-Wave Alliance CT200-G1, User Manual

Page: 21 / 34

CT200-G1 User Guide
Configure Menu
The Configure Menu provides access to set the HVAC system, comfort control settings, and network settings.
Equipment Be sure to turn the thermostat operating mode to OFF before changing HVAC setup
Heating menu configures heat type, heat fuel, and stages.
If Heat Pump type, additional menu options are available.
Type Forced Air, Heat Pump, Radiant
Fuel Natural Gas, Propane, Fuel Oil, Geothermal, and Electric For Heat Pump
Stages 1(single), 2(dual). If Heat Pump, additional stages available 1 + Auxiliary, 2 +
Auxiliary, and 2 + 2 Auxiliary.
O/B Wire O activated for Cool, B activated for Heat.
Cooling menu configures cooling type and cooling stages
Type Air Conditioning, Heat Pump, or Evaporate.
Stages 1(single) or 2 (dual).
Network joins or unjoins the Thermostat to a Z-Wave Network.
Before starting this procedure, go to your Z-Wave controller and prepare it for new devices.
Connect joins the Z-Wave network.
Disconnect unjoins the Z-Wave network.
Calibrate offsets the temperature measurement.
Calibration range is -5.0 to +5.0 degrees.
Cycling sets an offset to the current room temperature before the heating or cooling system will turn on.
The Cycling can be from 0.5F to 4.0F. For example, if Cycling is set to 2.0F and the Thermostat is set
to 70F target temperature, the heat cycle will start when the room temperature drops to 68F. Similarly,
the cooling system will start when the room temperature increases to 72F. The HVAC runs until the
room reaches the target temperature, and then shuts off.
Staging sets an offset from the room temperature at which the next stage in multi-stage systems will engage
to bring the room temperature back to the target temperature.
The default is 2 degrees Fahrenheit, and the range is 2 degrees Fahrenheit to 6 degrees Fahrenheit.
Reset clears Z-Wave settings and restores Z-Wave settings to factory default.
Reset does not affect Thermostat settings.
Use this procedure only if the Z-Wave network primary controller is missing or inoperable.
The Thermostat automatically resets and reboots the Z-Wave radio. You will need to reconnect the
Thermostat to your Z-Wave network.
Configure Menu 17