Z-Wave Alliance CT200-G1, User Manual

Page: 34 / 34

CT200-G1 User Guide
FCC Warning
Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful
interference in a residential installation This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation If this equipment
does cause harmful interference to radio or television reception (which can be determined by turning the
equipment off and on), try to correct the interference by following these suggestions:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Statement Of Use
Compatible with all popular residential HVAC systems: 24VAC single stage and two stage conventional
heating systems (gas, oil, electric), heat pumps with up to two stages of heat and up to two stages of
auxiliary heat (electric or fossil), zoned forced air and zoned hot water (2 or 3 wire), millivolt systems (with a
12- 24V AC or DC source), one or two stage cooling, and hybrid systems. Do not use this thermostat with
with line voltage heating systems.
30 Chapter 3. Z-Wave Reference