Z-Wave Alliance CT200-G1, User Manual

Page: 20 / 34

CT200-G1 User Guide
Device Menu
The Device menu provides access to change temperature units, display wake-up, testing, and information.
Units display either Fahrenheit or Celsius temperature units.
The Thermostat can display room temperatures in a range from 28F to 99F (-2C to 37C) with incre-
ments of 0.5 (F or C).
Display affects the wake-up from sleep behavior of the Thermostat.
The Thermostat must be powered by C-Wire for this option. Button Tap is default mode when Ther-
mostat is powered by AA batteries.
Approach Wake-up when person approaches Thermostat.
Button Tap Press +/- or side button to wake-up the display.
Info shows information about the Thermostat.
Power Supply the active source (batteries or 24VAC C-Wire).
Battery Level remaining battery power.
HVAC Configuration type of heating and cooling.
Relays the active wires being used by the system.
Network Z-Wave Network connection status.
Software versions for Thermostat (D) and Z-Wave (Z).
Testing runs heating or cooling for up to 30 minutes as a system test.
You can stop a test at any time by selecting Stop and pressing the side button. If Thermostat is con-
figured for Heat Pump, the minimum time between tests is four minutes to avoid activating Compress
Delay protection.
Do not test Cooling if the outside temp is below 65F.
Time duration of test in minutes and seconds.
Active wires the system with the heating system.
Change the temperature change caused during the test.
A succesful test is:
• Positive temperature change if Heating.
• Negative temperature change if Cooling.
• Proper wires active.
An unsucceful test suggests:
• Check the wire connections
• Verify HVAC system configuration
16 Chapter 2. Operation Guide