Z-Wave Alliance CT200-G1, User Manual

Page: 24 / 34

CT200-G1 User Guide
The thermostat can be removed from the Z-Wave network process similar to the inclusion process.
Set your primary controller to EXCLUDE.
Z-Wave Repeater functionality is enabled for all line powered devices in a Z-Wave network.
When power is first applied to this device it will broadcast a Hail message followed by a Node Informa-
tion frame. This behavior is to maintain backwards compatibility with older controllers that work with
this line of devices.
The Thermostat’s node type is fixed when it is included to the Z-Wave network; if the C-Wire is not
connected and is only battery-powered when including to the network, the Thermostat will remain a
frequent listening routing slave (FLiRS) node until it is removed from the network.
When your thermostat is running on battery power, the Z-Wave radio will turn off to help con-
serve battery life. The Thermostat Z-Wave radio module supports Z-Wave beaming, which
allows other devices in the network to wake up the Z-Wave module and accept commands
and then go back to sleep.
When your thermostat is running on C-Wire power, the Z-Wave radio will stay on and actively
help route messages within the Z-Wave network. The thermostat’s node type is fixed when
it is included to the Z-Wave network; if the C-Wire is present and powered when including
to the network, the thermostat will remain an always- listening node until it is removed from
the network
Security 2 is suppored by this device.
Table 1: Supported Command Classes
Category Command Class Security Level
Application Basic n/a
Application Configuration Authenticated
Application Multilevel Sensor Authenticated
Application Thermostat Fan Mode Authenticated
Application Thermostat Fan State Authenticated
Application Thermostat Mode Authenticated
Application Thermostat Operating State Authenticated
Application Thermostat Setpoint Authenticated
Management Association Authenticated
Management Association Group Info Authenticated
Management Battery Authenticated
Management Device Reset Locally Authenticated
Management Firmware Update Meta Data Authenticated
Management Manufacturer Specific Authenticated
Management Version Authenticated
Management Z-Wave Plus Info non-secure
Network Powerlevel Authenticated
Transport Security S2 non-secure
Transport Supervision non-secure
Transport Transport Service non-secure
Lifeline is supported by this device.
The device only supports Association Group 1, which can hold up to 2 nodes.
If at least one node is added to association group one (1), the thermostat will send the following reports
when the respective state has changed:
• Basic Report
20 Chapter 3. Z-Wave Reference