Z-Wave Alliance CT200-G1, User Manual

Page: 9 / 34

CT200-G1 User Guide
Prepare Wires
Make sure your wires are labeled. If necessary, find the “other end” connection for each wire on your heating
or air conditioning equipment and note the label there.
• Fan out wires so that they are aligned with their terminals.
• Do not bunch wires in front of the mounting plate.
• Feed any slack back into the wall.
Follow these guidelines for safe and secure wire connections:
• Use at least 3 inches of wire for each of your connections to the Thermostat.
• Splice additional wire to allow enough slack.
• Use 16-22 awg for connection to thermostat terminal blocks.
• Remove approximately 1/8 inch of insulation from the tip of each wire.
• Take care not to damage the labels for each wire.
If you have both RH and RC connections, you must set the RC/RH Switch to OPEN If you do not have both
connections, set the switch to CLOSED.
Warning: Do not allow wires to touch each other or other parts on the thermostat.
Wiring 5