York AYK 550, User Manual

Page: 200 / 283

196 AYK550-UH User’s Manual
Serial Communication – FBA
Relay Output Control
Using the fieldbus for relay output control requires:
• Drive parameter values set as defined below.
• Fieldbus controller supplied, binary coded, relay command(s) in the appropriate
location. (The location is defined by the Protocol Reference, which is protocol
dependent.)
1. More than 3 relays requires the addition of a relay extension module.
Note! Relay status feedback occurs without configuration as defined below.
Analog Output Control
Using the fieldbus for analog output control (e.g. PID setpoint) requires:
• Drive parameter values set as defined below.
• Fieldbus controller supplied analog value(s) in the appropriate location. (The
location is defined by the Protocol Reference, which is protocol dependent.)
Drive Parameter Value Description
Protocol
Reference
1401
RELAY OUTPUT
1 35 (
COMM
)
36 (
COMM
(-1))
Relay Output 1 controlled by fieldbus.
1402
RELAY OUTPUT
2 Relay Output 2 controlled by fieldbus.
1403
RELAY OUTPUT
3 Relay Output 3 controlled by fieldbus.
1410
1
RELAY OUTPUT
4 Relay Output 4 controlled by fieldbus.
1411
1
RELAY OUTPUT
5 Relay Output 5 controlled by fieldbus.
1412
1
RELAY OUTPUT
6 Relay Output 6 controlled by fieldbus.
Drive Parameter Value Protocol Reference
0122
RO
1-3
STATUS
Relay 1…3 status.
0123
RO
4-6
STATUS
Relay 4…6 status.
Drive Parameter Value Description
Protocol
Reference
1501
AO
1
CONTENT SEL
135 (
COMM VALUE
1) Analog Output 1 controlled by
writing to parameter 0135.
–
0135
COMM VALUE
1 –
1502
…
1505
AO
1
CONTENT MIN
…
MAXIMUM AO
1
Set appropriate
values.
Used for scaling –
1506
FILTER AO
1 Filter time constant for
AO
1. –
1507
AO
2
CONTENT SEL
136 (
COMM VALUE
2) Analog Output 2 controlled by
writing to parameter 0136.
–
0136
COMM VALUE
2 –
1508
…
1511
AO
2
CONTENT MIN
…
MAXIMUM AO
2
Set appropriate
values.
Used for scaling –
1512
FILTER AO
2 Filter time constant for
AO
2. –