6-12
IM WT5000-02EN
Setting the Bar Graph Display Type (Graph)
4.
Tap
Graph
to select Bar.
Switching the Displayed Group (Group)
5.
Tap
Group
to select a group from Group1 to Group4.
You can select up to four groups. The Item and Form settings, explained later, are applied to the group
numbers you select in this step.
Switching the Display Group When Displaying Bar Graphs
Like the graph display, flick to switch the display group (see section 6.2).
Switching the Displayed Items (Items)
Select the voltages and currents of the input elements to be displayed with bar graphs.
6.
Tap
Items
. The following screen appears.
Select the displayed item number.
The number increases from top to bottom on the bar graph screen. To show the No.2 and No.3 item
numbers on the bar graph display, set the screen division to Dual or triad in the display format settings
explained later.
Closes the menu
Set the displayed item.
You can set the following items for displaying measurement functions.
U
(harmonic voltage),
I
(harmonic current),
P
(harmonic active power),
S
(harmonic apparent power),
Q
(harmonic reactive power),
λ
(harmonic power factor),
Φ
(phase difference between harmonic voltage and harmonic current),
ΦU
(phase difference between each harmonic voltage and the fundamental wave),
ΦI
(phase difference between each harmonic current and the fundamental wave),
Z
(load circuit impedance),
Rs
(load circuit series resistance),
Xs
(load circuit series reactance),
Rp
(load circuit parallel resistance),
Xp
(load circuit parallel reactance)
Input element to be configured (Element1 to Element7)
Select the vertical scale's setup method (Fixed, Manual).
Set the vertical scale type (Linear, Log).
This soft key is displayed when you set the vertical scale mode to Manual.
Set the upper limit (0 to 9.999 T).
This soft key is displayed when you set the vertical scale mode to Manual.
Set the X-axis position (Bottom, Center).
This soft key is displayed when you set Scale Mode to Manual and Vertical Scale
to Linear.
6.4 Bar Graph Display
