YOKOGAWA EXAxt ZR22G, User Manual, Page: 106 / 211

<7. Startup>
7-9
IM 11M12A01-02E
Enter
Display setup

Calibration setup

Blow back setup

mA-output loop check

Contact check
Maintenance
F7-12.ai
Enter
Display item

Trend graph

Auto return time: 0min

Language: English
Display setup
F7-13.ai
Figure 7.19 Maintenance Panel Display Figure 7.20 Display Setup
Enter
Primary value:
Humidity

Secondary value:
mA-output1

Tertiary value:
mA-output2

Tag name:
Display item
F7-14.ai
Primary value:
Oxygen

Secondary value:
mA-output1

Tertiary value:
mA-output2

Tag name:
Enter
Oxygen
Humidity
Mixing
Item of output1 damping
Item of output2 damping
Display item
F7-15.ai
Figure 7.21 Display Item Display Figure 7.22 Display Item Selection
Table 7.2 Display Items
Item Primary value Secondary and
tertiary values
Display
Oxygen
concentration
○ ○
Oxygen concentration during measurement
Humidity
○ ○
Humidity (%H
2
O) in the exhaust gas
Mixing ratio
○ ○
Mixing ratio during measurement
Relative humidity
○
Relative humidity calculated from the measured value
Dew point
○
Dew point calculated from the measured value
Output 1 item
○ ○ Oxygen concentration with the equipment set for oxygen
analyzer (See *1 below.)
Output 2 item
○ ○ Oxygen concentration with the equipment set for oxygen
analyzer (See *1 below.)
Current output 1
○
Current value output from analog output 1
Current output 2
○
Current value output from analog output
*1: If an analog output damping constant is set, the oxygen concentration display then includes these settings.
NOTE
For the relative humidity and dew-point calculations, appropriate operation parameters should
be entered. For details on the parameters, consult Section 8.6.3, “Setting Measurement Gas
Temperature and Pressure,” later in this manual.
16th Edition : Mar. 19, 2020-00