7. OPERATION
114
7.9.5 Mullion Cutting from the list
For the mullion cutting from the list, press the
" Serial Cut "
button and switch to the
" Mullion Cutting "
mode.
You need to make sure that you are in the mullion cutting mode.
The list is adjusted according to the desired profile length. Below is the current list.
The profile height in the intermediate registration mode and this value should be entered correctly if the profile
is used under the profile. For example; if it is considered that a profile of 50 mm height is not used and below
the elevation angle, it is set as follows.
Summary of Contents for DC 550
Page 1: ...www yilmazmachine com tr ...
Page 61: ...7 OPERASYON 60 ...
Page 118: ...7 OPERATION 117 ...
Page 175: ...7 ОПЕРАЦИЯ 174 ...
