7. OPERATION
106
7.8.6.11 Adjustment of Machine Cutting Calibration;
In case cutting angles are not perigon, calibration equipment’s of this angle are situated behind the
machine.
Open the rear cover of head which is behind the machine. The adjusting equipment’s are under the
cover
( FIGURE – 42 ).
Remove the saw valve, behind the head, and be careful that engines are turned off, dismount manual
saw by using thin screwdriver
( FIGURE – 43 ).
Obtain a miter to adjust 90 degree
( FIGURE – 44 ).
Check that the angle between machine table and saw is 90 degree. In case that the angle is different
than 90 degree, adjust the angle by using bolts as shown below figure
( FIGURE – 45 ).
FIGURE – 42
FIGURE – 43
Summary of Contents for DC 550
Page 1: ...www yilmazmachine com tr ...
Page 61: ...7 OPERASYON 60 ...
Page 118: ...7 OPERATION 117 ...
Page 175: ...7 ОПЕРАЦИЯ 174 ...
