YILMAZ DC 550, Operator'S Manual

Page: 92 / 187

7. OPERATION 91
7.8.1 MANUAL CUTTING PAGE
7.8.1.1 General Properties

When the manual cutting button is pressed, the following page appears. ( FIGURE – 20 )

In manual cutting mode, the desired part size and cutting angles are entered manually.
7.8.1.2 Cutting Length and Angle Setting

The length of the part to be cut is entered in the length field.
 For fixed head angle adjustment, the angle settings on the left side of the
screen are used.

For moving head angle adjustment, the angle settings on the right side of the
screen are used.
 45º and 90º cutting angles can be entered by pressing the ready buttons on the
screen.

For example; if you want to cut a piece of length 2206 mm by 45º, the length value is entered as
shown below ( FIGURE – 21 ) , the left side is set to 45º and the right side is set to 45°.

º Press the go button to measure button on the screen or go to Measure button on
the control panel to send the machine to the cutting dimension.
FIGURE – 20