Yealink VC400, Administrator'S Manual

Page: 83 / 299

Configuring Network
67
A dialog box pops up to prompt that the settings will take effect after a reboot.
6.
Click
OK
to reboot the phone.
To configure VLAN via the remote control:
1.
Select
Menu
->
Advanced
(default password: 0000) ->
Advanced Network
.
2.
In the
VLAN
block, check the
Active
checkbox.
3.
Enter the VLAN ID in the
VID(1-4094)
field.
4.
Enter the priority value (0-7) in the
Priority
field.
5.
Press the
Save
soft key to accept the change.
The display device prompts “Reboot now?”.
6.
Select
OK
to reboot the system immediately.
DHCP VLAN
The system supports VLAN discovery via DHCP. When the VLAN Discovery method is set to
DHCP, the system will examine the DHCP option for a valid VLAN ID. The predefined option 132
is used to supply the VLAN ID by default. You can customize the DHCP option used to request
the VLAN ID. For more information on VLAN, refer to
VLAN Feature on Yealink IP Phones
.
Parameters of VLAN feature on the system are described below.
Parameter Description Configuration Method
DHCP
VLAN
->
Active
Enables or disables the DHCP VLAN
discovery feature on the system.
Default:
Enabled
Note
: If you change this parameter,
the system will reboot to make the
change take effect.
Web User Interface
Option
Configures the DHCP option from
which the system obtains the VLAN
settings.
You can configure at most five DHCP
options and separate them by
commas.
Valid Values:
128-254
Default:
132
Note
: If you change this parameter,
the system will reboot to make the
change take effect.
Web User Interface