Yealink T3 Series IP Phones User Guide
35
l
Select
Far Hold
(
FarHold
) to hold the party. The held party cannot hear anyone, and no one can hear the
held party.
l
Select
Remove
to remove the party from the conference call.
Ending a Conference Call
When you end the conference call, the other parties drop the call.
However, the system administrator can set up your phone so that the other two parties remain connected when you
end the conference call.
Procedure
1.
Select
End Call
(
EndCall
).
Network Conference
If your system administrator has set a network conference feature on your phone, you can initiate a conference with
two or more contacts.
Topic
Setting Up a Network Conference
Setting Up a Network Conference
You can set up a network conference with two or more contacts.
Procedure
1.
Place a call to the first party.
2.
Select
Conference
(
Conf
).
The active call is placed on hold.
3.
Dial the second party’s number.
4.
When the second party answers the call, select
Conference
(
Conf
) to add the second party to the conference.
5.
Select
Conference
(
Conf
) to place a new call.
The conference call is placed on hold.
6.
Enter the number of the new party, and then press the OK key or
Send
.
7.
When the new party answers the call, select
Conference
(
Conf
) to add the new party to the conference.
8.
Repeat steps 5 to 7 until you add all parties.
Note
: The procedures for setting up a network conference call on specific servers may be different. Contact your system
administrator for more information.
Multicast Paging
Multicast Paging allows you to broadcast instant audio announcements to users who are listening to a specific mul-
ticast group on a specific channel.
The phone supports the following 31 channels:
l
0
: Broadcasts are sent to channel 0. Note that the Yealink IP phones running firmware version 80 or earlier can
be regarded as listening to channel 0. It is the default channel.
l
1 to 25
: Broadcasts are sent to channel 1 to 25. We recommend that you specify these channels when broad-
casting with Polycom IP phones which have 25 channels you can listen to.
l
26 to 30
: Broadcasts are sent to channel 26 to 30. We recommend that you specify these channels when broad-
casting with Yealink IP phones running firmware version 81 or later.
Note
: All IP phones in the multicast paging group must be deployed in the same subnet since a broadcast is used. The phone
can only send/receive broadcasts to/from the listened channels. Other channels’ broadcasts will be ignored automatically by
the IP phone.
