Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
429
Permitted
Values
0-Disabled, the call is parked by the current line, which is in call state.
1-Enabled
Default
0
Supported
Devices
All phones except T19(P) E2
Parameter features.call_park.performby_holdhardkey.enable <y0000000000xx>.cfg
Description It enables or disables the phone to park a call using the HOLD hard key.
Permitted
Values
0-Disabled
1-Enabled
Default
0
Supported
Devices
All phones except T48G, T46G, T42G, T41P, T29G, T19(P) E2 and CP920
Parameter sip.call_park_without_blf
[1]
<y0000000000xx>.cfg
Description It enables or disables the phone to close the BLF monitoring feature for call park DSS key.
Permitted
Values
0-Disabled
1-Enabled
Default
0
Supported
Devices
All phones except T19(P) E2 and CP920
[1]
If you change this parameter, the phone will reboot to make the change take effect.
Example: Setting Call Park and Retrieve in FAC Mode
The following example shows the configuration for the FAC call park mode.
Example
features.call_park.park_mode = 1
features.call_park.enable = 1
features.call_park.park_code = *68
features.call_park.park_retrieve_code = *88
After provisioning, the call park mode is set to FAC. A Park soft key will display on the phone during an active call,
and a Retrieve soft key will display on the Dialing screen. You can press the Park soft key to park a call or press
the Retrieve soft key to retrieve a parked call.
Tip
: You can set a line key as a Park key or a Retrieve key, specify an extension you want to park a call to for Park key and
specify a parked extension you want to retrieve a parked call from for Retrieve key. For more information, refer to
Example: Setting Call Park and Retrieve in Transfer Mode
The following example shows the configuration for Transfer call park mode.
Example
features.call_park.park_mode = 2
features.call_park.enable = 1
features.call_park.park_code = *01
