6 Installation and Wiring
6.1.3 Installing I/O Modules with Connectors
6-12
3) Disconnecting the Cable from the Module
Use the following procedure to disconnect the cable from the Module.
(1) Loosen the connector fixing screw.
(2) Remove the connector from the Module.
Note:
Inserting or removing a connector to/from the Module may cause chattering
in input signals. If this causes a problem, install a chattering prevention
switch for each Module and always turn the chattering prevention switch
OFF to turn OFF the input power supply before inserting or removing the
connector to/from the Module.
4) Removing the Module from the Mounting Base
Use the following procedure to remove the Module from the Mounting Base.
(1) Loosen the Module mounting screw on the Module.
(2) Rotate the Module until it disconnects from the Mounting Base.
(3) Remove the Module from the Module hook on the Mounting Base.
Module mounting screw M4
(Use a Phillips screwdriver.)
DC24IN-32P
DC24IN-32P
Module hook
Rotate
Module
connector
Mounting base
Module hook
Module
connector
DC24IN-32P
