8
YASKAWA
SIEP C730600 0NA MECHATROLINK-4 Technical Manual
NOTICE
Damage to Equipment. Do not use damaged parts to connect the drive and the option. Failure to comply
could damage the drive and option.
•
Make sure that the model number on the option nameplate and the model number on the purchase order are the
same. Refer to
for more information.
•
Contact the distributor where you purchased the option or contact Yaskawa or a Yaskawa representative about
any problems with the option.
◆
Option Package Contents
Table 3.1 Contents of Package
Option Contents
Quantity
Option
1
Ground wire
1
Screws (M3)
3
LED Labels
GA500
1
Quick Installation Procedure
1
*1
GA500 drives do not use the ground wire.
*2
LED labels are located on this label sheet.
Figure 3.1 LED Label Sheet
◆
Installation Tools
You can use these tools to install the option to the drive:
•
A Phillips screwdriver or slotted screwdriver
•
Non-conductive tweezers or a tool with a tip width of approximately 0.5 mm (0.02 in) to set DIP switch S1.
•
A pair of diagonal cutting pliers.
•
A small file or medium-grit sandpaper.
*1
Phillips screw sizes are different for different drive capacities. Prepare different screwdrivers for different
screw sizes.