YASKAWA GA80U4720ABM, Manual

Page: 140 / 1016

4.2 Keypad: Names and Functions
140 YASKAWA SIEPC71061737B GA800 Drive Technical Reference
Note:
•
Energize the drive with factory defaults to show the Initial Setup screen. Push (Home) to show the HOME screen.
–
Select [No] from the [Show Initial Setup Screen] setting to not display the Initial Setup screen.
•
Push from the Home screen to show drive monitors.
•
Push to set d1-01 [Reference 1] when the Home screen shows U1-01 [Frequency Reference] in LOCAL Mode.
•
The keypad will show [Rdy] when the drive is in Drive Mode. The drive is prepared to accept a Run command.
• The drive will not accept a Run command in Programming Mode in the default setting. Set b1-08 [Run Command Select in PRG Mode] to
accept or reject a Run command from an external source while in Programming Mode.
– Set b1-08 = 0 [Disregard RUN while Programming] to reject the Run command from an external source while in Programming Mode
(default).
– Set b1-08 = 1 [Accept RUN while Programming] to accept the Run command from an external source while in Programming Mode.
–
Set b1-08 = 2 [Allow Programming Only at Stop] to prevent changes from Drive Mode to Programming Mode while the drive is
operating.
Table 4.3 Drive Mode Screens and Functions
Mode Keypad Screen Function
Drive Mode Monitors
Sets monitor items to display.
Programming Mode
Parameters
Changes parameter settings.
User Custom Parameters
Shows the User Parameters.
Parameter Backup/Restore Saves parameters to the keypad as backup.
Modified Parameters/Fault Log
Shows modified parameters and fault history.
Auto-Tuning
Auto-Tunes the drive.
Initial Setup
Changes initial settings.
Diagnostic Tools Sets data logs and backlight.