YASKAWA
TOEPC7106171FD FP605 DRIVE INSTALLATION & PRIMARY OPERATION
23
1.
Move the front cover to connect the hooks at the top of the front cover to the drive.
A - Hooks
Figure 6.18 Reattach the Front Cover
2.
Move the front cover while pushing on the hooks on the left and right sides of the front cover until it clicks into
position.
Note:
Make sure that you did not pinch wires or signal lines between the front cover and the drive before you reattach the cover.
Figure 6.19 Reattach the Front Cover
3.
Reattach the keypad to its initial position.
Reattach the Terminal Cover
Wire the drive and other peripheral devices then reattach the terminal cover.
Note:
• Make sure that you do not pinch wires or signal lines between the wiring cover and the drive before you reattach the cover.
• Tighten the screws to a tightening torque of 0.98 N
∙
m to 1.33 N
∙
m (8.67 lbf
∙
in to 11.77 lbf
∙
in).
Figure 6.20 Reattach the Terminal Cover
■
Removing/Reattaching the Cover Using Procedure C
DANGER
Electrical Shock Hazard. Do not examine, connect, or disconnect wiring on an energized drive. Before servicing,
disconnect all power to the equipment and wait for the time specified on the warning label at a minimum. The internal capacitor
stays charged after the drive is de-energized. The charge indicator LED extinguishes when the DC bus voltage decreases below 50
Vdc. When all indicators are OFF, remove the covers before measuring for dangerous voltages to make sure that the drive is safe. If
you do work on the drive when it is energized, it will cause serious injury or death from electrical shock.
