YASKAWA
TOEPC7106171FD FP605 DRIVE INSTALLATION & PRIMARY OPERATION
15
Drive Weight
Persons Necessary to Move the Drive
< 15 kg (33 lbs.)
1
≥ 15 kg (33 lbs.)
2 + using appropriate lifting equipment
Refer to the Technical Reference for information about how to use suspension systems, wires, or hanging metal
brackets to move the drive.
◆
Using the Hanging Brackets to Move the Drive
Use the hanging brackets attached to the drive to temporarily lift the drive when you install the drive to a control
panel or wall or when you replace the drive. Do not let the drive stay vertically or horizontally suspended or move the
drive over a long distance while it is suspended.
Before you install the drive, make sure that you read these precautions:
WARNING
Crush Hazard. Before you hang the drive vertically, use screws to correctly attach the drive front cover and other
drive components. If you do not secure the front cover, it can fall and cause minor injury.
WARNING
Crush Hazard. When you use a crane or hoist to lift the drive during installation or removal, prevent more than
1.96 m/s
2
(0.2 G) vibration or impact. Too much vibration or impact can cause serious injury or death from falling equipment.
WARNING
Crush Hazard. When you lift the drive during installation or removal, do not try to turn the drive over and do not
ignore the hanging drive. If you move a hanging drive too much or if you ignore it, the drive can fall and cause serious injury or
death.
WARNING
Crush Hazard. When you install the drive, do not hold the front cover. Install the drive with holding the heatsink. If
you hold the front cover, the cover will come off and the drive will fall, then it can cause injury.
◆
Installation Position and Distance
Install the drive vertically for sufficient airflow to cool the drive.
A - Vertical installation
B - Horizontal installation
Figure 6.1 Installation Position
■
Single Drive Installation
Use the clearances specified in
to install the drive. Make sure that there is sufficient space for wiring and
airflow.
NOTICE
Damage to Equipment. Remove the top protective cover from the drive when you install IP20/UL Type 1 models
2011 to 2169, 4005 to 4052, and 4077 to 4156 in an enclosure or when you install the drive with the heatsink external to the
enclosure. If you do not remove the cover, the drive temperature will increase and it can cause damage to the drive.
NOTICE
Damage to Equipment. Do not remove the top protective cover of model 4065. If you remove the cover, the drive
temperature will increase and it can cause damage to the drive.
Note:
When you install models 2011 to 2169 and 4005 to 4156 in an enclosure or when you install the drive with the heatsink external to the
enclosure, set
L8-35 = 0 [Installation Method Selection = IP20/UL Open Type]
.
