Specifications
14.3.5 Digital Operator and Connector Cables
1
4
-54
J
PIN1 Power Supply Cable Mounting
Connect the P1N1 Power Supply Cable according to the following steps.
1. Turn the cable connector so that the two grooves on the tip are facing left, and then connect the cable.
2. Connect the Inverter using the left connector of the two connectors.
When inserting the connectors, check that the clasp locks with a snap.
Make sure the
2 connector
grooves are
facing left.
Red line
Power supply
terminal screws
Converter
Inverter
Power supply
terminal screws
P1N1 power supply Cable
Flat cable
Insert into leftmost connector.
Busbars (x2)
Fig 1
4
.19 Busbar and Cable Mounting (With Upper Cover Open)
14.3.5 Digital Operator and Connector Cables
Operations, such as displaying the status of control signals, displaying and setting control constants, and
displaying protection function operations can be performed by mounting an optional JVOP-132 Digital
Operator to the Inverter.
J
Digital Operator and Extension Cables
A Digital Operator Extension Cable (72616-W5301 or 72616-W5303, sold separately) is required to con-
nect a JVOP-132 Digital Operator to the Inverter. Digital Operators and Cables are not supplied with the
Inverter, but must be purchased as needed. Refer to
2.4 Mounting and Dismounting the Digital Operator
and to
Chapter 5 Operating the Digital Operator
for mounting and operating procedures.
Product
Model
Details
Digital Operator
JVOP-132
Use the Digital Operator in combination with an Extension Cable to
set and reference Inverter constants.
Extension Cable
(1 m (3.28 ft))
72616-W5301
Use an Extension Cable to connect the Inverter and the Digital
Operator. The following are supplied with the Extension Cable:
Cable (1 m or 3 m) (3 28 ft to 9 84 ft) x 1
Extension Cable
(3 m (9.84 ft))
72616-W5303
Cable (1 m or 3 m) (3.28 ft to 9.84 ft) x 1
Cable clamp
x 1
2 types of tapping screws 3 x 10
x 2
14
INFO
Summary of Contents for CIMR-M5 Series
Page 12: ...Notes for Motor xi...
