
9
2. Before operating the unit
Installation procedures/precautions
(8)
Handling the controller
・
Using optional
“remote control communication cable (product code:281397)”, “remote control
power unit (product code:281399)
”, you can remove the control panel off the main unit and
remotely control an IL series controller.
・
A
“remote control panel stand (product code: 281398)” is also available for removed panel.
This stand is useful when the main unit is installed in a draft chamber or a clean room, or
when remotely controlling the main unit.
【
Removing the control panel
】
1) Make sure that the breaker is at [OFF].
2) Remove the knurled screws that secure the control
panel to the main unit. (Two points at the lower part)
3) Slowly slide the control panel upward.
4) Slowly remove the cable that connects between the
main unit and the control panel off the cable jack. The
cable is two-forked and has two jacks.
※
Excess length of the cable is only about 10 cm
from the main unit.
Insert the optional communication cable and the
remote operation power cable to the appropriate
connectors.
Refer to the section
“Remote Control Connection of
the Control Panel
” of the “Operation manual for the
model CR5 Program Controller
”.
DC5V power connector 3P
Connector for internal
communication 2P