21
3. PRE-OPERATION PROCEDURES
Installation Procedure
1. Connect the water supply hose securely.
●
Take out water supply hose set (tap connector, water supply hose) from among the
accessories. Install unit on a level and stable location close to a water tap and sink.
●
Improper connection may cause water supply hose or tap connector to come off, resulting
in water splash or leakage.
●
Note that tap connector can possibly break when fastened more than necessary.
2. Make connection on the water tap side.
(1)
Slide the sleeve of
③
Hose
connector on the tap side in the arrow direction. Tap
connector and water supply hose can be separated.
(2) Loosen
②
Plug
from
①
Ring
.
(3)
Uniformly fasten four
⑤
Set screws
while pressing
①
Ring
slightly to the tap so that
⑥
Gasket
contacts evenly with the tap spout. Where the tap is a laboratory tap, adjust
the position that
⑤
Set screws
come into the lowest trough of the tap spout as shown in
the figure below.
(4) Turn
②
Plug
to fasten securely. This will seal the tap and tap connector with
⑥
Gasket
.
(5) Slide the sleeve in the arrow direction and insert
③
Hose connector
into
②
Plug
.
Release the sleeve of
③
Hose connector
and it will return to its original position. This
completes the connection.
* A valve is provided in tap connector. Water stops when
③
Hose connector
comes off.