5
■
Location
Do not install the controller in locations where it is:
• subject to extreme temperature and humidity
• subject to sulfuric or corrosive gases
• subject to dust or oil smoke
• subject to direct sunlight, or splashing by rain or water
• subject to mechanical vibrations and shock
• subject to high-voltage lines, welding machines and sources of electric noise
• less than 15 m from high-voltage ignition devices
• subject to electromagnetic fields
• subject to flammable liquids or vapor
■
Removing the SDC10T Case
The following instructions show how to remove the SDC10T body from the case. This
has to be carried out only when the controller is to be replaced:
●
Required tools
Small standard screwdriver
Press the claw on the lower left side of the mask bezel with your finger.
Insert the screwdriver into the groove between the mask bezel and the controller body.
Press the claw while turning the screwdriver.
Take hold of the front end of the body as it is forced out of the case and pull it out.
Mask bezel
Case
Handling Precautions
●
Turn the power OFF before carrying out the above procedure.
●
In the case of the socket model (C10S), internal components cannot be drawn
out.
Chapter 3 MOUNTING
1
2
3
4
