Yamaha 250GETO, Service Manual

Page: 286 / 293

i-1 6S35H11
Index
A.
Adjusting the throttle cable ...................... 3-8
Adjusting the throttle sensor .................. 4-12
Adjusting the timing plate ...................... 5-46
Adjusting the trim sensor .........................7-20
Aft view ......................................................8-6
After test run .......................................... 1-29
Applicable model ..................................... 1-5
Assembling the carburetor ..................... 4-11
Assembling the crankshaft .................... 5-35
Assembling the crankshaft
roller bearing ........................................ 5-36
Assembling the drive shaft housing
......................................................6-17, 6-48
Assembling the forward gear..........6-16, 6-39
Assembling the fuel pump ..................... 4-15
Assembling the gear pump ......................7-36
Assembling the lower case.............6-16, 6-47
Assembling the oil seal housing ............ 5-36
Assembling the oil tank ...........................4-18
Assembling the piston and connecting rod
assembly .............................................. 5-37
Assembling the power unit .................... 5-37
Assembling the propeller shaft
assembly 1.............................................6-42
Assembling the propeller shaft
assembly..................................................6-9
Assembling the propeller shaft
housing .........................................6-10, 6-40
Assembling the PTT motor ......................7-30
Assembling the relief valve ......................7-35
Assembling the reverse gear ...................6-47
Assembling the upper case .....................7-10
B.
Backlash (counter rotation model) ...........6-61
Backlash (regular rotation model)............6-27
Bleeding the oil pump .............................4-19
Bottom cowling ..........................................7-1
Bracket ................................................... 3-10
Bracket/upper case................................. 1-15
Break-in ................................................. 1-28
C.
Carburetor ................................................ 4-6
Changing the gear oil ............................ 3-12
Charging system ......................................8-20
Checking relief valve................................7-34
Checking the anode ............................... 3-13
Checking the armature ............................8-18
Checking the battery .............................. 3-14
Checking the bearing .....................6-15, 6-46
Checking the bearings ........................... 5-30
Checking the brush..................................8-19
Checking the carburetor ........................ 4-10
Checking the CDI unit................................8-9
Checking the charge coil .........................8-13
Checking the check valve .......................4-18
Checking the choke solenoid ....... 3-10, 8-19
Checking the compression pressure ....... 5-1
Checking the connecting rod big end side
clearance ............................................. 5-34
Checking the connecting rod small end axial
play ...................................................... 5-34
Checking the cooling water passage.........3-4
Checking the cooling water pilot hole .... 1-28
Checking the crank position sensor.........8-11
Checking the crank position
sensor air gap ........................................8-12
Checking the crankshaft ........................ 5-34
Checking the cylinder bore .................... 5-32
Checking the cylinder head ................... 5-22
Checking the drive shaft.................6-15, 6-46
Checking the electrical component............8-1
Checking the emergency switch ..............8-23
Checking the engine idle speed .............. 3-7
Checking the engine oil level.................... 3-3
Checking the engine start switch.............8-15
Checking the engine start switch and engine
stop lanyard switch .............................. 1-27
Checking the engine stop
lanyard switch ........................................8-16
Checking the engine temperature
sensor ....................................................8-12
Checking the exhaust cover .................. 5-20
Checking the filter ....................................7-34
Checking the fuel filter .............................. 3-2
Checking the fuel joint and fuel hose
(fuel joint-to-carburetor) ......................... 3-2
Checking the fuel pump ......................... 4-14
Checking the fuel system ...................... 1-25
Checking the fuse ....................................8-15
Checking the gear oil ............................. 1-25
Checking the gear oil level .................... 3-11
Checking the gear pump .........................7-34
Checking the gear pump housing............7-34
Checking the gear shift and throttle
operation ................................................1-27
Checking the gear shift operation ............ 3-9
Checking the hour meter .........................8-22
Checking the hydraulic pressure .............7-24
Checking the ignition coil ...........................8-9
Checking the ignition spark gap ................8-8
Checking the ignition timing .................... 3-9
Checking the lighting coil .........................8-20
6S35H11_2index 05.9.20 19:02 Page 2