60H5E11
Bracket unit
BRKT
1
2
7-23
60H70480
5
60H70470
4
Disassembling the PTT motor
1. Remove the PTT motor, O-ring, filter, and
drive pin.
60h70450
Make sure that the tilt rod and trim rods are
fully extended when removing the PTT
motor. If they are not, fluid may spurt out
from the unit due to the internal pressure.
Do not push down the tilt and trim rods
while the PTT motor is removed. Fluid may
spurt out from the unit.
2. Clean the filter, and check it for damage.
Replace the filter if it is damaged.
3. Slide out the lead holder
1
and rubber
spacer
2
. Then, slide out the stator
3
.
Remove the stator
3
.
60h70460
NOTE:
Place a clean cloth over the end of the arma-
ture shaft, and hold it with a pair of pliers, while
pulling out the stator
3
carefully.
4. Remove the armature.
Do not allow grease or oil to contact the
commutator while working on it.
5. Disconnect the blue(L) lead
4
.
60h70470
NOTE:
Hold down the brush while pulling out the lead.
6. Disconnect the green (G) lead
5
, and re-
move the brush
6
.
60h70480
• Do not pull out the PTT motor lead from
the stator.
• Do not touch the bimetal
A
A
A
A
A
, otherwise the
operation of the circuit breaker may be
affected.