60H5E11
5
E
Axial play limit:
2 mm (0.08 in)
T
R
.
.
Piston, Connecting rod
5-34
Connecting rod:
1st : 19N • m (1.9kgf • m, 14 ft • lb)
2nd : 36N • m (3.6kgf • m, 27 ft • lb)
3rd : Loosen completely
4th : 19N • m (1.9kgf • m, 14 ft • lb)
5th : 36N • m (3.6kgf • m, 27 ft • lb)
8. Install bearings and connecting rods to the
crankshaft.
9. Measure the axial play at the connecting
rod big end. Replace the bearing and the
connecting rod if the measurement is out
of specification.
60H50640
NOTE:
For measurement, set the dial gauge at the
connecting rod small end in parallel to the crank
shaft.
10. Measure the connecting rod side clearance.
Replace the connecting rod if the measure-
ment is out of specification.
60H50630
Connecting rod side clearance:
0.12 - 0.26 mm (0.0047 - 0.0102 in)
at 20°C (68 °F)
Bearing inner race attachment:
90890-06662
11. Check the crankshaft journal bearings. Re-
place the bearings if necessary.
Installing the crankshaft
1. Install the crankshaft bearing, and the cir
clip.
60H50650
2. Install the two roller bearings to the center
of crankshaft.
NOTE:
• Dowel hole on the roller bearings shall face
the engine bottom.
• Install the roller bearings so that the split ends
are engaged correctly.
3. Install the seal rings on the crankshaft.
